Model 900 Machine Serial # ____________ Engine Model & Spec # ____________ Engine Serial # ____________ Purchase Date
STUMP GRINDER LIMITED WARRANTY EXPLANATION OF LIMITED WARRANTY The manufacturer will not reimburse the customer or dealer labor cost incurred
Warranty Validation Form Congratulations on your purchase of a Carlton Stump Grinder. This product has been designed and manufactured to provide yea
TABLE OF CONTENTS INTRODUCTION FOREWORD 1 MACHINE FEATURES 2 MACHINE SPECIFICATIONS 3 OPERATI
FOREWORD 1 Congratulations on your purchase of a new Carlton® Professional Stump Grinder
MACHINE FEATURES 2 • Gas Power • Heavy construction • Tapered roller bearings on cutter wheel. • 1/2”
MACHINE SPECIFICATIONS 3 Engine...Honda 9
SAFETY PRECAUTIONS 4 Read and understand this manual as well as the engine manual supplied with your unit before
DAILY CHECKLIST 5 • Check engine oil at dipstick. Take reading with engine sitting level. Add reco
MACHINE OPERATION 6 STARTING - READ ENGINE MANUFACTURERS OWNERS MANUAL BEFORE STARTING. • Check all flu
MACHINE OPERATION 7 • NEVER ATTEMPT TO MAKE ANY ADJUSTMENTS TO THE UNIT WHILE ENGINE IS RUNNING (EXCEPT WHERE
MACHINE OPERATION 8 • Unlock the brake, move the machine further forward, reset the brake, and resume the grin
MACHINE MAINTENANCE 9 − Check engine oil at dipstick with engine sitting level. Add recommended oil and change o
MACHINE MAINTENANCE 10 − To adjust V-belt tension, loosen the four bolts on the engine plate (See Figure 1). Then, e
TROUBLE SHOOTING GUIDE 11 COMPLAINT CAUSE CORRECTION Engine will not start. (see Engine Manufacturer Manual
SERVICING CUTTER WHEEL 12 SAFETY - DO NOT OPERATE MACHINE WITHOUT A FULL SET OF TEETH. There are twelve (12) teeth to a
SERVICING CUTTER WHEEL 13TOOTH ARRANGEMENT • Inspect pockets, teeth and bolts for damage and replace as required. • When
DIESEL ENGINE EXHAUST WARNING CALIFORNIA Proposition 65 Warning Diesel engine exhaust and some of its constituents are known to the Stat
SERVICING CUTTER WHEEL 14 TOOTH SHARPENING Begin by removing the exposed area of the steel shank shown above with a
CHIP GUARD ASSEMBLY 15 ITEM NO PART NO DESCRIPTION QTY 1 900108E Chip Guard Skirt - Left 1 2 9001
THROTTLE AND BRAKE ASSEMBLY 16 ITEM NO PART NO DESCRIPTION QTY 1 0150510 Brake Lever Assembly 1 2 0150510A Brake Cable
AXLE ASSEMBLY 17 ITEM NO PART NO DESCRIPTION QTY 1 900100 Frame Weldment 1 2 900101
BELT GUARD ASSEMBLY 18 ITEM NO PART NO DESCRIPTION QTY 1 900112 V-Belt Guard Cover 1 2 0150712 7/
HARDWARE ASSEMBLY 19 ITEM NO PART NO DESCRIPTION QTY 1 900105 Safety Shut-Off Bar 4 2 - Spring
CUTTER WHEEL ASSEMBLY 20 ITEM NO PART NO DESCRIPTION QTY 1 0150107 1/2”-13 x 2” 4 2 0150304 1/2” Flat
STUMP CUTTERS MODEL TYPE ENGINE HP FUEL CUTTINGDEPTH CUTTINGHEIGHT CUT SWING NO. TEETH WHEELDI
900 SAFETY ALERT
900 SAFETY ALERT
STUMP GRINDER LIMITED WARRANTY J.P. Carlton Co. Inc., hereafter referred to as the “Manufacturer”, warrants each new Carlton Grinder to be fre
Kommentare zu diesen Handbüchern