Carlton 1712 Betreibershandbuch PDF herunterladen (Seite 102)

12” CHIPPER SERVICE

CUTTER SYSTEM

SHARPEN KNIVES

• Have knives ground by a qualified

grinder.

• Grind knives at 29° to 31°.

• Before and after grinding the knife-edge,

check the width of the knife from the

center of the hole to the sharp edge of

the knife. Never use a knife with this

measurement below 1 13/16”.

• Three factors for a good cutting

system are:

1. Never use a knife with the

distance from the cutting edge

to the center of the bolt hole

less than 1 13/16”.

2. Always use knives in sets of

two with the dimension from

the cutting edge to the center of

the bolt hole as close as

possible to each other.

3. Never use a knife if the back

edge is inside the knife pocket

edge.

KNIVES

PART NO DESCRIPTION QTY

0900114 7.25” x 4” x 1/2” Knife 2

0900125

1/2” Knife Bolt – Special Design – Purchase from

JP Carlton or Dealer

0900126

1/2” Security Lock Nuts – Purchase from JP

Carlton or Dealer

09001142 6.093” x 4” x 1/2” Knife 2

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 164 165

Keine Kommentare

Carlton 1712 Betreibershandbuch Seite 102