Carlton 1712 Betreibershandbuch PDF herunterladen (Seite 117)

12”CHIPPER SERVICE

FEED WHEEL MOTOR

Replace with new motor. Clean the threads

on the motor, the 1” nut, and the coupling

with degreaser before beginning to replace

all the parts.

Attach the torque arm to the new motor

using the 1/2” bolts that were removed.

Tighten the bolts and torque to 120 ft. lbs.

(The torque arm looks slightly different on

the lower feed motor, but is still held on

with two bolts.)

Put the coupling onto the motor and line up

key and keyway – always use new key. Use

a rubber mallet to seat the coupling. Strike

the coupling a couple of times. Apply

LocTite 262 (red) to the 1” nut and screw in

place. Torque the nut to 150 ft. lbs. Strike

the coupler again a couple of times with the

rubber mallet to finish seating and torque the

nut to 150 ft. lbs. again.

HIT COUPLING WITH RUBBER MALLET TO SEAT

LINE UP KEY WITH KEYWAY ON COUPLING

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 164 165

Keine Kommentare

Carlton 1712 Betreibershandbuch Seite 117