Carlton 1712 Betreibershandbuch PDF herunterladen (Seite 52)

12” CHIPPER MACHINE CONTROLS

26

• Two hydraulic valves control the winch

on this chipper. The hydraulic winch

selector valve diverts hydraulic fluid

from the feed roller circuit and enables

the hydraulic winch circuit. Once the

hydraulic winch circuit is enabled the

winch control valve controls the

hydraulic winch motor.

• The 9” chipper winch selector valve is

located on the hydraulic valve box.

There is a decal that shows the proper

operation (pictured at the right). Push

the valve to the left to turn the feed

wheels on and to the right to turn the

winch on.

• The winch control lever is the right hand

lever on the hydraulic control lever

panel.

 There is a decal next to the lever to

show proper operation of the winch

control. After the rope has been

attached to the tree, push the lever

in to pull the tree to the chipper.

Also use this lever position to

rewind the rope.

 Pull the lever back to release the

pressure on the rope to remove the

rope from the tree once it has been

pulled to the chipper and has been

put into position to be run through

the chipper.

 After use of the winch is finished

use the winch control lever to

rewind and secure the rope before

running the feed wheels. (The

winch selector will have to be

turned back to the Feed Wheels On

position to feed the tree through the

chipper.)

• NEVER ALLOW ANYONE TO

OPERATE THE WINCH CONTROL

VALVE WHILE AN OPERATOR IS

IN THE VICINITY OF THE WINCH

ROPE!!! ROPE BURNS OR OTHER

INJURIES COULD OCCUR IF THE

PERSON BECAME ENTANGLED OR

TRIPPED BY THE ROPE.

HYDRAULIC WINCH

CONTROL VALVE

HYDRAULIC WINCH

SELECTOR VALVE

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 164 165

Kommentare zu diesen Handbüchern

Keine Kommentare