Carlton 2518 Betreibershandbuch PDF herunterladen (Seite 44)

18” DRUM MACHINE CONTROLS

It is imperative that all operators are familiar with all controls of the chipper. This will make for

a much more productive and safer work period. (The actual controls may differ depending on

the engine supplied with your chipper.)

ENGINE CONTROLS:

• For the John Deere 170HP engine, the

Key Switch and Gauges are located in a

lockable panel at the rear of the engine.

Always turn off the engine and remove

the key from the switch before

performing service or maintenance of

any kind.

• The engine is supplied with a three-

position key switch. Turn the key

clockwise all the way to start the engine;

always start the engine at idle. When the

engine is running, release the key and it

returns to the on (run) position. Turn the

key counter-clockwise to shut down the

engine.

DO NOT OPERATE THE ENGINE

AT AN ANGLE GREATER THAN

25° OR SEVERE ENGINE DAMAGE

WILL OCCUR. PROPER ENGINE

OIL LEVEL MUST BE MAINTAINED

TO ACHIEVE MAXIMUM ANGLE

OF OPERATION OF 25°. (See Engine

Owner’s Manual for proper oil level.)

• A throttle switch is located next to the

key switch. The lower (idle) position is

for starting the engine, low speed engine

operation during warm up, clutch

engagement/disengagement, and engine

cool down. The upper position is for

running the engine at full speed during

chipping operations.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 198 199

Keine Kommentare

Carlton 2518 Betreibershandbuch Seite 44