Carlton 2518 Betreibershandbuch PDF herunterladen (Seite 54)

18” DRUM MACHINE CONTROLS

• The winch drum rotates counter-

clockwise when pulling in loads. If the

rope needs to be replaced make sure it is

started under the drum.

• Winding the rope over the top

(clockwise) could cause the rope to rub

on the encasement and wear the rope

causing fraying and breakage. Always

wind the rope under the winch drum.

• Read the winch instruction manual for

complete information.

WINCH CONTROL VALVE

(OPTIONAL EQUIPMENT #2)

• There is a second option for the winch

on the drum chipper. This winch has a

different style spool. This style of winch

uses the same hydraulic controls as the

previous winch. The operation of the

spool is different. The freewheel

selector is located on the right side of the

winch drum assembly.

 Pull out the lock pin and push the

freewheel bar down to put the winch

in freewheel position. The operator

can now pull out the rope. NEVER

ALLOW ANYONE TO OPERATE

THE WINCH CONTROL VALVE

WHILE AN OPERATOR IS IN

THE VICINITY OF THE WINCH

ROPE!!!

 Once the winch rope is attached to

the material to be winched to the

chipper, pull the freewheel bar back

up engaging the winch drive motor

to the winch drum.

ALWAYS WIND ROPE

UNDER THE WINCH

DRUM

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 198 199

Keine Kommentare

Carlton 2518 Betreibershandbuch Seite 54