Carlton 2518 Betreibershandbuch PDF herunterladen (Seite 75)

18” DRUM MACHINE MAINTENANCE

FUEL FILTER & FUEL/WATER

SEPARATOR

Replace the fuel filter every 500 hours of

operation or 6 months. Follow the engine

owner’s manual on how to remove the filters

and to drain the fuel/water separator. Only

use engine manufacturer approved fuel

filters. Make sure to clean the area around

the fuel filter before removing any parts; do

not take a chance on contaminating the fuel

line. Do not leave spilled fuel on the

machine; spilled fuel on hot engine parts can

cause fires.

COOLANT SYSTEM

• Check the coolant level daily when the

engine is off and all parts are cool.

Remove the coolant filler cap slowly to

relieve built up pressure.

• When adding coolant to the tank, leave

at least 1/2" between the coolant and the

bottom of the filler pipe. Anti-freeze

ratio to water must be 50/50, never use

100% anti-freeze.

• Clean the coolant filler cap and check

the caps’ gaskets for damage. Replace

the cap if the gaskets are damaged.

• Inspect the coolant system for leaks.

(For other service on the coolant system

refer to the engine owner’s manual.)

• Be sure to replace the filler cap before

starting the engine.

• John Deere engines require a special

coolant additive. Read your engine

owner’s manual for additional coolant

information.

Pressurized System: Hot coolant can cause

serious burns. To open the cooling system filler

cap, stop the engine and wait until the coolant

system components are cool. Loosen the cooling

system pressure cap slowly in order to relieve the

pressure.

COOLANT FILLER CAP

FUEL/WATER SEPARATOR

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 198 199

Kommentare zu diesen Handbüchern

Keine Kommentare

Carlton 2518 Betreibershandbuch Seite 75

Kommentare zu diesen Handbüchern