Carlton 2518 Betreibershandbuch PDF herunterladen (Seite 98)

18” DRUM SERVICE

CUTTER SYSTEM

71

DANGER: Do not open the cutter drum

door until the cutter drum has come to a

complete stop. Do not perform service on

the cutter drum or knives without

installing the drum lock pin.

• Remove the padlock and lock pin from

the cutter drum door and open.

• The cutter drum lock pin will have to be

removed to rotate the cutter drum and

inspect the knives. Use extra care when

rotating the cutter drum to prevent

injury. Rotate the drum fully to check

for any obstructions or binding. If any

problems are found, correct them before

proceeding. DO NOT ROTATE THE

DRUM BY HAND ALWAYS USE A

PRY BAR. Always wear leather

gloves when performing any service

on the cutter drum system.

DANGER – KNIVES ARE

EXTREMELY SHARP

• Inspect all four knives. If knives are still

in good shape, proceed with other

inspections or maintenance. To change

knives, follow these procedures.

• Install the cutter drum lock pin. Rotate

the cutter drum slowly to line up and

insert the pin.

• Remove the six bolts and nuts holding

each knife in place on the cutter drum.

• Inspect the bolts and nuts carefully for

worn, chipped, or stripped threads.

• Do not remove and replace knife bolts

and nuts more than 3 times before

replacing with new bolts and nuts.

• Nuts are security lock nuts. DO NOT

USE ANY OTHER STYLE OF

NUTS. You must purchase these nuts

from Carlton or an authorized dealer.

CUTTER DRUM DOOR LOCK PIN

CUTTER DRUM LOCK PIN

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 198 199

Kommentare zu diesen Handbüchern

Keine Kommentare