Carlton 2518 Betreibershandbuch PDF herunterladen (Seite 45)

18” DRUM MACHINE CONTROLS

18

• Also in the control box is a diagnostic

gauge/hour meter. The configuration at

the right is typical for this engine; but

may vary depending on the make and

model of the engine supplied with your

chipper. Read the engine manufacturer’s

manual to fully understand all the

functions of this gauge.

• This gauge will show the engine speed,

oil pressure and temperature, warning

codes for engine problems, and the hours

of operation.

• The Auto-Feed Plus® monitors the

engine RPM and controls the feed

system based on this information. The

Auto-Feed is calibrated when installed in

the chipper with a high and low RPM

setting for the feed wheels to operate.

When the engine RPM is low and the

Auto-Feed is on, the hydraulics will not

work. If large diameter wood is being

chipped and the engine RPM drops

below the Auto-Feed Low setting, the

Auto-Feed will stop the feed wheels.

After the engine RPM is high enough to

handle the force required to chip this

material without causing the engine to

lug down, the Auto-Feed restarts the

feed wheels.

• The Auto-Feed Plus

® control is

calibrated to automatically come on

when the chipper is started. If you need

to turn on the Auto-Feed Plus® control,

press and hold the right button down for

4 seconds and release.

• The Auto-Feed must be turned off to

operate the hydraulics at low engine

RPM or idle. When the Auto-Feed is on

the hydraulics only work when the

engine RPM is high. To operate the feed

wheels at low engine RPM, turn off the

Auto-Feed by pressing and holding the

left button for 4 seconds and release.

• Read the Auto-Feed Plus® manual

supplied at the end of this manual if

programming is required.

AUTO-FEED OFF AUTO-FEED ON

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 198 199

Kommentare zu diesen Handbüchern

Keine Kommentare