Carlton SP8018 TRX Spezifikationen PDF herunterladen (Seite 43)

SP8018 TRX MACHINE OPERATION

• Cutter head swing speed should be

adjusted to a rate that will allow cutter

wheel to pass through stump smoothly.

If jerking, bouncing or significant drops

in engine speed occur, swing rate is too

rapid and must be decreased.

• Swing speed should be determined and

adjusted with the controls in the full

open position.

• A counter-rotating valve is located

within the hydraulic system to adjust the

speed. Turning the handle clockwise

will open the bypass and slow swing

action. Turning it counter-clockwise

will increase swing rate.

• Lower spinning cutter wheel to stump

and make a few light passes at stump to

get a feel for the cutting action.

• Gradually increase cutting action and

work away at stump by swinging cutter

wheel left- to-right-to-left through stump

in a sideways motion. Smooth,

effortless cutting lengthens machine life,

minimizes downtime and is more

profitable in the long run.

• Continue cutting stump by adjusting

cutting wheel progressively lower until

stump is cut well below ground level.

• Raise and swing cutter wheel clear of

stump and position machine closer to

stump for next series of passes. Lower

and continue cutting.

• Continue in this manner until stump has

been removed.

• Larger stumps may require repositioning

machine to work at best advantages.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 100 101

Keine Kommentare

Carlton SP8018 TRX Spezifikationen Seite 43