Carlton SP8018 TRX Spezifikationen PDF herunterladen (Seite 66)

SP8018 TRX SERVICING HYDRAULICS

46

• Replace hydraulic filter every three to

four months of normal use. More often

if used under severe conditions. Use a

10-micron filter, available at most

locations.

• Unscrew old filter and discard properly.

Clean filter housing and install new

filter, making sure old O-ring has been

removed and new filter has a new O-ring

in place. Screw in new filter hand tight

only. Recheck oil level and refill if

needed, as described above.

HYDRAULIC OIL COOLER

(only on remote control machines)

• There is a hydraulic oil cooler on all

remote control machines to keep the

hydraulic oil from over heating. There is

a temp sensor in the bottom of the oil

cooler and if the oil temperature rises to

140° or higher the fan comes on to cool

the oil. The fan may go on and off as the

temperature of the oil changes

depending on the environment and the

operation of the grinder.

• Keep the fins clean. Use a garden hose

and a mild detergent. Do not use a

power washer as it may cause the fins to

bend. Do not use an industrial strength

detergent that may cause the metal to

deteriorate.

• Inspect all connections and hoses for

leaks and wear. Replace if necessary.

Use extra care when inspecting hoses

with fluid under pressure. DO NOT use

your finger or hand to inspect for leaks,

use a board or cardboard. Follow all

safety procedures at the beginning of the

Servicing Hydraulics section.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 100 101

Kommentare zu diesen Handbüchern

Keine Kommentare