Carlton SP8018 TRX Spezifikationen PDF herunterladen (Seite 61)

SP8018 TRX SERVICING CUTTER WHEEL

TOOTH ARRANGEMENT

• Inspect pockets, teeth, and bolts for damage

and replace as required.

• When replacing pockets, always replace

new pockets across from each other in

order to prevent vibration.

• Replacement teeth must be carbide tipped

and have like design as provided with the

machine.

• Use anti-seize on threads to prevent bolts

from “freezing up” in cutter wheel pockets.

• When replacing complete set of teeth, be

sure to duplicate original factory tooth

arrangement.

• Torque bolts to 150 ft/lbs.

opposing outside pockets carry like arrangements of teeth to cancel vibration

• Straight teeth are mounted in TWO

OPPOSING OUTSIDE POCKETS.

• A straight tooth must have a 45° tooth

accompanying it in the same pocket set.

The opposite pocket set should have this

same combination of straight and 45° teeth,

except with positions reversed. Mounting

these teeth opposite each other on the

cutting wheel cancels damaging vibration.

• Two Other Opposing Outside Pockets, as

shown, must have 45° teeth overlapping

centerline of wheel to make plunge cuts

possible. Mount two left 45° teeth opposite

two right 45° teeth.

• All remaining outside pockets and all

inside pockets require 45° teeth mounted

away from the wheel.

• The second pocket in each group gradually

goes back into the cutter wheel for half a

rotation and then repeats.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 100 101

Keine Kommentare

Carlton SP8018 TRX Spezifikationen Seite 61